車庫門維修、窗使用較頻繁，也容易被損壞，平時若能多動一些腦筋，在使用與保養上掌握一些車庫門維修保養的技巧，就可給生活帶來方便。下面我們就一起來了解下車庫門的維修和保養方法。

　　Garage door maintenance and window use are frequent and easily damaged. If you can use your brain more and master some garage door maintenance skills in use and maintenance, it can bring convenience to life. Let's learn about the repair and maintenance methods for garage doors together.

　　車庫門的常見故障

　　Common faults of garage doors

　　1、用手動開關或遙控器不能啟動驅動裝置，驅動裝置沒有接通電源，手動開關或遙控接收板斷路，運行次數過多導致電機熱保護，檢查插座、插頭、手動開關、保險管熔絲，檢查手動開關及遙控接收板接線，重新定位行程開關以增加行程；

　　1. The driving device cannot be started with a manual switch or remote control, the driving device is not powered on, the manual switch or remote control receiving board is open circuited, and the motor thermal protection is caused by excessive operation. Check the socket, plug, manual switch, fuse tube, and wiring of the manual switch and remote control receiving board. Reposition the travel switch to increase the travel;

　　2、門關不嚴或開不完全，行程開關位置調節不正確，重新定位行程開關以增加行程；

　　2. The door is not tightly closed or fully opened, and the position adjustment of the travel switch is incorrect. Reposition the travel switch to increase the travel;

　　3、手動開關能控制驅動裝置而遙控器不能，遙控器未對碼，遙控系統故障，按照說明書指導完成對碼操作，更換遙控器內部電池，請維修人員檢查接收控制板；

　　3. The manual switch can control the driving device, but the remote control cannot. The remote control is not properly coded, indicating a malfunction in the remote control system. Follow the instructions in the manual to complete the coding operation, replace the internal battery of the remote control, and ask maintenance personnel to check the receiving control board;

　　4、門未關緊就自動反向運行或開門時未接觸行程開關就中途停止運行，開關門阻力大于設置啟閉負載力了障礙感應系統，連桿長度調節不當，拉開離合裝置，檢驗門體與扭簧是否平衡、啟閉是否靈活，增大開閉負載力，在門關閉時調節連桿長度；

　　4. The door automatically runs in reverse before it is tightly closed or stops running halfway without touching the travel switch when opening the door. The resistance to opening and closing the door is greater than the set load force, activating the obstacle sensing system. The length of the connecting rod is not adjusted properly. The clutch device is opened to check whether the door body and torsion spring are balanced and whether the opening and closing are flexible. The opening and closing load force is increased, and the length of the connecting rod is adjusted when the door is closed;

　　5、門體單向運行行程開關損壞或行程開關線短路，光電開關光路上有障礙物 啟閉負載力調節沒有到位，檢查行程開關及行程開關接線，光電形狀光路上的障礙物，重新調節啟閉負載力；

　　5. The one-way travel switch of the door is damaged or the travel switch wire is short circuited. There are obstacles on the photoelectric switch optical path, and the load force adjustment for opening and closing is not in place. Check the travel switch and its wiring, remove the obstacles on the photoelectric shaped optical path, and readjust the load force for opening and closing;

　　車庫門維修方法

　　Garage door repair method

　　1：檢查車庫內部的金屬軌道。查看將軌道固定到墻壁的安裝支架。如果支架松了，請擰緊螺栓或螺釘。將車庫門關上，在車？庫內部檢查軌道是否有凹陷、彎曲或變平的地方。如果有任何損壞之處，請用橡皮錘，或用一塊廢木料墊著錘子敲打這些地方。如果軌道嚴重?fù)p壞，您必須更換。

　　1: Check the metal tracks inside the garage. Check the installation bracket that fixes the track to the wall. If the bracket is loose, please tighten the bolts or screws. Close the garage door, in the car? Inspect the tracks inside the warehouse for any dents, bends, or flattening. If there is any damage, please use a rubber hammer or use a piece of scrap wood to cushion the hammer and strike these areas. If the track is severely damaged, you must replace it.

　　2：用水平儀檢查軌道，確保軌道在同一水平線上。水平軌道應當略向車庫后部傾斜，如果是卷簾門，軌道的縱向部分應精確垂直。在車庫的墻壁上，兩條軌道必須處于同一高度。如果軌道沒有準確對齊，請將固定安裝支架的螺釘或螺栓擰松，但不要把它們?nèi)∠聛恚缓笮⌒牡厍么蜍壍?，使它們移動到適當?shù)奈恢?。用水平儀重新檢查軌道，確保它們處于正確的位置；然后將安裝支架上的螺釘或螺栓擰緊。

　　2: Use a spirit level to check the track and ensure that it is on the same horizontal line. The horizontal track should be slightly inclined towards the rear of the garage, and if it is a rolling shutter door, the longitudinal part of the track should be precisely vertical. On the walls of the garage, the two tracks must be at the same height. If the track is not aligned accurately, loosen the screws or bolts that secure the mounting bracket, but do not remove them, then carefully tap the track to move them to the appropriate position. Recheck the tracks with a spirit level to ensure they are in the correct position; Then tighten the screws or bolts on the installation bracket.

　　3：用高濃度家用清潔劑清洗軌道，去除污垢和硬化的油脂。將轉軸徹底清洗干凈，然后將軌道和轉軸擦干。

　　3: Clean the track with a high concentration household cleaner to remove dirt and hardened grease. Thoroughly clean the shaft, then dry the track and shaft.

　　4：將石墨粉撒在軌道上，將家用潤滑油或硅樹脂噴在轉軸上，或者在軌道和轉軸上噴灑車庫門專用潤滑油噴劑，以起到潤滑作用。如果有滑輪，請您使用和用在轉軸上的相同的潤滑劑潤滑。

　　4: Sprinkle graphite powder on the track, spray household lubricating oil or silicone resin on the shaft, or spray garage door specific lubricating oil spray on the track and shaft to provide lubrication. If there are pulleys, please lubricate them with the same lubricant as used on the shaft.

　　車庫門保養

　　Garage door maintenance

　　我們主要的工作就是經常對軌道進行清潔，把軌道內部的雜物都去除干凈，這樣就不會影響門體的運動，如果門體有卡住現象發生，我們應該檢查扭簧和配件是否牢固，如有出現損壞的現象發生我們應該及時維修和更換。定期對電動車庫門的表面進行清潔，以免使用久了導致銹蝕等現象發生，在清潔的時候不能使用化學清潔劑來清洗，這樣會產生氧化對車庫門的漆面造成脫落。

　　Our main job is to regularly clean the track, removing all debris inside the track so that it does not affect the movement of the door. If the door gets stuck, we should check whether the torsion spring and accessories are secure. If there is any damage, we should repair and replace them in a timely manner. Regularly clean the surface of the electric garage door to prevent rusting and other phenomena caused by prolonged use. Chemical cleaning agents should not be used during cleaning, as this can cause oxidation and peel off the paint surface of the garage door.

　　我們的生活已經離不開汽車的使用，同時就必須要有車庫，但是我們在使用車庫的時候不要忽視了它的保養工作，到時候出現問題還是我們自己來處理，它的成倍大于保養工作，因此大家應該分清輕重，這樣才不會影響正常停車。

　　Our lives are inseparable from the use of cars, and at the same time, we must have a garage. However, when we use a garage, we should not ignore its maintenance work. If there are problems, we will have to deal with them ourselves. Its multiplication is definitely greater than maintenance work. Therefore, everyone should distinguish between the importance and importance, so as not to affect normal parking.

　　本文由 濟南卷簾門 友情奉獻.更多有關的知識請點擊 http://www.kmmhwl.com    真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Jinan Rolling Shutter Doors For more related knowledge, please click http://www.kmmhwl.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.