Generally, most of Jinan rolling shutter manufacturers will provide installation services for users, but some customers want to install their own rolling shutter products. So, what should I pay attention to when installing? What is the specific installation process? Here is the specific content of the installation.

　　基本的安裝過程:

　　Basic installation process:

　　1. 控制箱預留PVC管從底部到地面，穿過墻壁到外面，并與地面在一定距離內，供室外電路進入房間、接線、調試控制箱開關。

　　1. PVC pipe is reserved for the control box from the bottom to the ground, through the wall to the outside, and within a certain distance from the ground, for the outdoor circuit to enter the room, connect and debug the switch of the control box.

　　2. 調整開口的長度。如果條件允許，開口的全長可以進一步延長到一定長度。這樣檢查孔就可以變成一個小門，方便以后的檢查。

　　2. Adjust the length of the opening. If conditions permit, the full length of the opening can be further extended to a certain length. In this way, the inspection hole can be turned into a small door for later inspection.

　　3.當電源被引導到控制箱的下端時，需要有漏電保護裝置，該裝置被PVC覆蓋。確定通信室內控制箱的位置，即操作電動卷簾門開關的設備的位置。

　　3. When the power supply is led to the lower end of the control box, leakage protection device is required, which is covered by PVC. Determine the position of the control box in the communication room, that is, the position of the equipment operating the electric rolling shutter door switch.

　　4. 安裝完成后，鋪設軌道時，應與軌道上的地面配合。鋪設軌道時，注意路面，防止軌道彎曲。

　　4. After installation, when laying the track, it shall cooperate with the ground on the track. When laying the track, pay attention to the road surface to prevent the track from bending.

　　5. 另外，安裝后要進行質量測試?？癸L(fēng)卷簾門是由電機控制升降簾子，需要檢查門升降時是否有緩沖過程。這是衡量門質量的重要指標。

　　5. In addition, quality test shall be carried out after installation. The anti wind rolling shutter door is controlled by the motor to lift the curtain. It is necessary to check whether there is a buffer process when the door is lifted. This is an important indicator of door quality.

　　安裝的注意事項:

　　Precautions for installation:

　　1、卷簾門安裝位置上端應設置可靠的防火裝置。在制作包裝箱或天花板時，應在門輪的下端安裝可拆卸蓋板。電動卷簾門機的下端側應預留一個可拆卸的人孔，以方便檢修。

　　1. Reliable fire protection device shall be set at the upper end of the installation position of the rolling shutter door. When making the packing box or ceiling, the removable cover plate shall be installed at the lower end of the door wheel. A detachable manhole shall be reserved at the lower side of the electric rolling shutter door machine to facilitate maintenance.

　　2、操作卷簾門時，操作者應站在查看門運行狀態的位置，否則容易發生事故。

　　2. When operating the roller shutter door, the operator shall stand at the position to check the operation status of the door, otherwise accidents may occur easily.

　　3、不要接觸酸或堿溶液，以防止窗簾表面腐蝕。

　　3. Do not touch acid or alkali solution to prevent corrosion of curtain surface.

　　卷簾門在運行中，應定期檢查滑動、傳動等部件，并根據需要及時加油，以保證門的正常使用。

　　During the operation of the rolling shutter door, the sliding, transmission and other components shall be checked regularly, and oil shall be added timely as required to ensure the normal use of the door.

　　防風的百葉窗

　　Windproof shutter

　　5、防風百葉窗在開關停止過程中,應該停止的功能與地位,不應該停止和繼續滑動現象,如滑動距離太大,應立即在快門控制電器和快門機器上剎車仔細檢查和修復,操作正常。

　　5. In the process of switch stop, the function and position of the windproof shutter should be stopped. It should not stop and continue to slide. If the sliding distance is too large, the shutter control appliance and shutter machine should be braked immediately to check and repair carefully. The operation is normal.

　　6、做好門的保養和保養，特別是對于卷簾門容易生銹的部位需要定期進行防腐、噴漆和保養處理，不能使用重物、硬物沖擊門面。

　　6. Do a good job in the maintenance of the door, especially for the parts easy to rust on the roller shutter door, which need regular anti-corrosion, painting and maintenance treatment, and do not use heavy objects or hard objects to impact the door surface.

　　7、卷簾門操作時若有大震動或異常聲音應停止檢查，排除障礙物使窗簾正常啟閉的雜物。

　　7. In case of large vibration or abnormal sound during the operation of rolling shutter door, the inspection shall be stopped to remove the sundries that make the curtain open and close normally due to obstacles.

　　門安裝好后，測試一下，看看是否有什么地方?jīng)]有安裝好。另外，用戶平時一定要做好防風卷簾門的維護和保養工作，以免出現門機出現故障問題，影響正常工作。如果用戶不知道如何操作，可參考以上內容進行清洗處理，以延長門的使用壽命。

　　After the door is installed, test to see if there is any place not installed. In addition, the user must do a good job in the maintenance of the windproof rolling shutter door at ordinary times, so as to avoid the failure of the door machine and affect the normal work. If you don't know how to operate, you can refer to the above content for cleaning treatment to extend the service life of the door.

　　以上是濟南卷簾門廠家小編為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://www.kmmhwl.com

　　The above is the relevant content introduced by Jinan roller shutter manufacturer. If you want to know more, please visit the website: http://www.kmmhwl.com